I was taught to paint by a professional and when estimating the amount of paint needed, I always allow for a second coat just to make sure of coverage. We interviewed a painter who tried to tell me I bought poor quality paint without knowing where I purchased it, and stated he would have to buy all new paint. He had not seen the cans and was just guessing so I asked him where I should buy paint from now on. It was the same place I had purchased my paint and he wanted to charge me an extra 20 a gallon more than what I paid for. Needless to say, I have interviewed numerous painters and they are not all honest.
The expression 'you get what you pay for' can be applied to nearly every profession. Of course you need to hire the painter that suits your budget however, the cheapest painting estimate may not include everything and you may end up paying more in the end. Painters usually bid their projects based on an hourly rate and they need to account for prep time, supplies, type of paint, ceiling height, difficult access points, and number of people working. When receiving a price estimate, ask the painter to break down the cost as specifically as possible so you understand where your money is going and ask about any required deposits or schedule of payments. Ask the painter to talk through potential unexpected costs that may throw off your budget. It's best to clarify all projected costs in the beginning before the work begins.
I managed commercial construction projects for many years, have built and remodeled several properties, and never once have I encountered any of these scams. The tone of this article is deeply troubling. The author seems to be saying that ALL painting contractors are inherently dishonest, and that has not been my experience. The underlying advice here is sound: get it all in writing and cover as many contingencies as possible--so pointing out potential pitfalls like coat coverage is helpful. But do that in the spirit of clear communication of expectations, not with the expectation that the person you are hiring will try to cheat you at every turn. Not every contractor takes outrageous advantage of change orders; not every contractor will sneak past necessary preparation and/or repairs. Contractors of all sorts get a bad rap as it is; reinforcing a stereotype with articles written from this point of view just seems unproductive.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."