To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.

I sent a request for a quote via yelp and this company's response was to call them. Lazy. I then called the office and spoke with the secretary named Teresa. When she asked for my address I asked if I could wait to give out that information (i was hoping to speak with someone first) which was followed up quickly with attitude and ego. My response was, " you need to be nicer to potential clients." It's such a shame that customer service is non existent most the time. I will happily make phone calls to other drywall installers, there are only a hundred of them to choose from...
Nothing is more frustrating that not being on the same page as your professional. During your in-home meeting, clarify your expectations of the job and have the painter set appropriate expectations on his or her end as well. If you want the painter to show up at an exact time every day, or if you need them to leave at a certain time, see how your schedule might impact the completion time. Additionally, ask the painter about their expectations for the job like requiring a staging area for supplies, needing to use the driveway, or having access to running water. Don't forget to ask about the clean up and disposal expectations and find out if they need access to your garbage receptacle or if they plan on leaving extra paint with you.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."

Painting Contractors Co

×