I disagree with your criteria to hire a painter. A prompt returned call is nice but does not indicate the quality or fairness of the painter. As far as a written estimate, that should be more of a qualifier for the bid versus an evaluation criterion. I'm not sure one would have favorable results by hiring a painter on this basis. As far as the bidding process, change orders should ONLY be used if the customer requests additional scope (PMP 101). Angie's list should consider asking reviewers if/how much they were told to pay compared with the estimate. Unfortunately, there are a lot of contractors that are unethical and need to be accountable.
Repaint — exteriors especially — before visible signs of wear appear, Bancroft says. Don’t wait until you see peeling or flaking paint. “If I have to spend 40 hours preparing the surface before we can paint, that time is going to result in a lot of extra costs. But if I can spend 10 hours preparing the surfaces to be painted, you’re going to save money,” Freeman says.
Sorry it is difficult to trust almost anyone in the trades. It is easier to do the work myself and not deal with strangers in and around my house. When I have to hire someone I tell them up front that I'll be checking every detail, pay extra to purchase the materials myself, and if they don't want the job - well good! I always fine someone who will work with me as I pay a bonus for that.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Steve, not only did you come off with an edge regarding the article written for Angie's list but you came awfully close to being slanderous. The article was written if you will have read his bio by a very well established professional painter. The issue regarding the deposit was put in question by a responder. I have read your response in full as you suggested, and companies as large as yours are just as likely to use the tricks of the trade as the small guy as you suggest, if not more so. A large company has less oversight and workers get lazy with the boss not looking over their shoulder. I have had experience in this area, and thought that i was dealing with a very reputable company that had been recommended by a couple friends, my insurance company, and my adjuster who had dealt with the company. I had terrible problems with the company, who do full restorations and like your company paint in all areas. To finalize your statement that Established businesses do not cheat customers is completly false and is a very misleading statement. I am suprised that Angies list allowed you to post such an outragious comment. All you have to do is look in the Civil lawsuits section of the Established businesses that are being sued or are under investigation for fraud and cheating their customers!
Hi Elaine, We would be happy to get you connected with a painting and wallpaper pro. You can submit a service request on our website: http://www.homeadvisor.com/ or browse reviews for local pros here: http://www.homeadvisor.com/c.html. We can also have a project advisor reach out to assist you if you send your contact information to [email protected] –HASupport
As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced.
Contractors apply several layers of paint to achieve a suitable finish. They leave the first coat to dry for the recommended time and apply one or more finishing coats. They might choose paints with special qualities for different types of room. Manufacturers have developed paints for bathrooms or kitchens that have good resistance to moisture for example. When they have completed painting, they clear away any equipment and restore the area to its original condition.
Even if you go it alone, specialize to keep your initial investment low. If you do only interior painting, for example, you might get by with one ladder, a few brushes, rollers, basic hand tools and such, for an investment of less than $300. Again, you can add to your tools as you need to (every job is a bit different), and parlay profits into the equipment necessary for exterior painting or working on large commercial properties.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
There's no denying that a fresh coat of paint (whether interior or exterior) can significantly improve the appearance of a property. While other home improvement projects might claim to add more value or function to your home, painting has long been a popular way to boost curb appeal or create a more pleasing atmosphere indoors. When it comes time to paint your home, there are basically only two options: do it yourself or hire a professional home painter. Sacramento homeowners will find that both of these paths have their good and bad points, but for those who want the best job possible in the shortest amount of time (not to mention with the least amount of effort), there is simply no substitute for hiring a pro.
As any painter will tell you, prep work is just as important -- if not more important -- than the paint application itself. If the paint on your house is chipping or peeling, it needs to be scraped and sanded smooth before applying a new finish. In most cases, you won’t need to remove all the existing paint, but scraping, sanding, patching, caulking, and priming are critical steps that take place before the start of most exterior painting jobs.
My husband has been a professional painter over 30 years. He prides himself in his high level of work ethic and customer satisfaction. He stays up to date on techniques and finishes. He gives Very detail and accurate appraisals with contracts. At an alarming rate, as he starts to finish the last day or the day before, the client starts nit picking and being disrespectful towards his work when every day prior to that, they were very pleased, as he request ongoing satisfaction throughout the job. Then they don't to want pay remaining balance, bicker about final cost, or stop payment. He has a crew he has to pay whether the customer does or doesn't honor the contract as well as our own household expenses. Wasted time ,labor, money and effort lost. Now how do we fix this? Remind yourself and clients that a contract is based on honor.