WE met with 3 different painting companies before we met James Lee and when we did we knew we wanted him to work on our project. We had only planned to paint the trim on our house and James did not try to talk us into any additional work, though after our initial meeting, we decided to paint the entire exterior of our home. I base my review on the following criteria for which I will give 5 stars in each category.
When you go to the home improvement store, find out how much 12 gallons of the paint you want would cost, and that will help you determine your cost. Maybe it's a low-quality paint that costs $30, in which case you're looking at about $360 for paint. If you choose high-quality paint that costs around $70, your total paint cost could be closer to $840. Professionals also recommend that you add an extra 10 or 20 percent to your total square footage, depending on the type of siding you have. Some textures require extra paint because they're rough. This is especially true with wood and stucco siding.
As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced.
Thanks, all, for your time & efforts adding to the article & comments, especially Dave urging requesting both General Liability AND Worker Compensation insurance certificates to protect from real & fraudulent liability--from my experience especially in California, where insurance fraud is a popular income thief, even causing car collisions to collect.
I was taught to paint by a professional and when estimating the amount of paint needed, I always allow for a second coat just to make sure of coverage. We interviewed a painter who tried to tell me I bought poor quality paint without knowing where I purchased it, and stated he would have to buy all new paint. He had not seen the cans and was just guessing so I asked him where I should buy paint from now on. It was the same place I had purchased my paint and he wanted to charge me an extra 20 a gallon more than what I paid for. Needless to say, I have interviewed numerous painters and they are not all honest.
Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
In some cases, professional painters may include additional charges for specialized equipment that homeowners can't purchase on their own. Because professionals have licenses and access to such equipment, it's simpler to let them get those themselves. But providing some of the smaller equipment and extras directly really can help to cut down on the total cost of your project.
Consider purchasing supplies personally to save money. Ask the painter for a bid that separates labor and materials. Then explain that you'll purchase the materials and ask for a list of exactly what will be needed to complete the job. Caulking, for example, is an extra supply commonly used to fill any cracks or damaged areas in your walls -- and one that might be overlooked in an incomplete list.
Hi Donnie, Thanks for your comment! We would be happy to help you connect with a fencing pro to give you an estimate on your project. You can submit a request to our pros here: www.homeadvisor.com, browse a list of local pros here: http://www.homeadvisor.com/c.html, or send your info to [email protected] and a project advisor will reach out to assist you. –HASupport
With that said, here's the reality of that particular scenario. Painters do put water in the paint, but not for reasons you would think. Some materials need to have their viscosity manipulated in order to slow drying time, allowing gravity to 'smooth' out the product for a better finish. It also prevents 'drags' and 'sausages'. I personally try not to do it too often, but from time to time I have to. I want my client to have a proper finish.
Interesting information! We just got scammed in White Stone, Virginia... we chose the same color, but went from a flat to an eggshell finish. I wasn't available to stand over the painter while he painted. For such a detailed job, I marveled at how quickly he finished the project! After he was paid for the job, we discovered all he did was roll paint across the walls and close to the crown, baseboards and detailed trim around windows and doors leaving about an inch or so of the flat finish. By using the same color, he didn't even do the job he was paid to do, which explained why he could finish the job so quickly. By using the same color... he got lucky and passed it off as a completed job not bothering to paint to and cut in around the trim. Upon further evaluation of our walls we could see exactly where he stopped because we could see the difference between the flat and eggshell finishes. There are walls he didn't even bother to paint. Then where he did paint near the crown when we were in the room watching ... he hit the crown moulding and tried to tell us it was already there... and tried to sell us on painting the crown moulding. I am so disgusted and upset!! He'll be hearing from us to rectify the situation.
I agree with JHs. If there is no new color on it at all, just talk to the painter about it, if it was an honest mistake (which can happen very easily while painting) your painter should have no problem fixing it. However, in my years of experience, it is not unusual for 2 coats of door paint (good quality) not to cover very well at all. I once painted a red door 7 times, plus a tinted prime coat before I found the door to be a solid color.
Due to the generally mild weather in and around Sacramento, home painters are able to conduct business for a big portion of the year without worry of freezing temperatures or torrential downpours. This means that, even when dealing with an exterior paint job, you'll be able to find a company that deals specifically with painting on a regular basis. Professional painter will be very efficient and can get the job done in a fraction of the time it would take most homeowners (even with a crew of friends ready to help). Aside from efficiency your local Sacramento house painters will also be extremely well versed in what holds up well in your area, and should be able to give you excellent suggestions on styles, brands, or even colors of paint that will work well for your situation.
Second coats on similar colors are almost never recogicnized as being needed until the coat is applied and has dried. ONLY THEN WILL YOU SEE WHETHER IT NEEDS A SECOND COAT or not. Yes, painters can use a cheaper paint then what you paid for. That is solved by getting your own which, I would charge extra for because I will always have to go get more, or add second coat because home owner tried to skimp on paint, or they got the wrong color etc...
WOW! I think the guy I hired read this first and I have photos that would make your skin crawl. Bottom line: he got me for $1900.00. Every single thing he painted had to be completely redone....that's when I discovered he did NOT use the colors I picked, he actually used leftover exterior paint from his mother's house! Because I have pets he said things needed to be sealed first and I did agree to that. What I did NOT agree to was using some kind of foul smelling gray stuff ON MY HARDWOOD FLOORS! THEN he painted them BLACK, telling me that all they were good for was covering over with laminate or carpet. He also dripped and tracked paint all over my ceramic tile floors. PLUS left a wet used paint roller in my garden window and had stuff piled in front so I didn't find it until it had dried. I have no idea how much that is going to cost to repair. Then he left without finishing (thank God) but left the "leftover" paint, uncovered, in the rain. Again, hid it so I didn't immediately find it. Obviously we will be going to court but I doubt if I see a penny from him.
Wilson & Hampton provides the premier system for coating metal surfaces. Electrostatic painting is an efficient process where you can upgrade and rejuvenate your entire office or factory area in your choice of finishes at a fraction of the re-placement cost. Cabinets, lockers, machinery, Bathroom Partitions and much more can be painted in-shop or on-site by drawing the paint directly to the metal surface to be painted and â€œwrappingâ€ around it, leaving no drips, spatter, or over spray.
Some contractors work on time and material others on a firm contract. I would never hire the former and am leary of the latter. A contractor may low-ball a bid to get the job planning to make a killing on change orders. If you say good morning to them, they charge you extra for that. If the contract is not very, very specific and extensively fleshed out or if they display their change order schedule prominently on top, show them the door.